Router/Bridge
y Support 1 or 4 Ethernet LAN ports
y Support 1 WAN port for multiple interfaces: E1/ DS1/ DTE (V.35, V.36, EIA530, RS449, RS232, X.21, RS422)
y Support 10/100 BaseT speed autosensing and half/ full duplex auto
negotiation.
y Support Router or Bridge mode
y Multicolor LED indicators.
y Local control and diagnostic via DB9S
console port. y Local/ remote management through
local console, LAN, or WAN
y Support CLI (command line interface)
y Support SNMP management
The Loop-IP6610 Router/Bridge provides connectivity from 10/100 BaseT LAN to E1/ DS1/ DTE WAN in a small metal box.
Loop-IP6610 Router/Bridge support DB9S console port, which allows users to execute in-service diagnostics and fault isolation from a local or remote terminal. Loop-IP6610 Router/Bridge also allow remote site to Telnet via Ethernet or WAN port. The IP6610 Router/Bridge series also provides multicolor LED indicators on the front panel and ACO (Alarm Cut-Off) button.
To specify options, choose from list below:
For E1 WAN portï¼s
For DS1 WAN portï¼s
Loop-IP6610-T-1ETH-BR-pp
For DS1 WAN port with In-band Managementï¼s
Loop-IP6610-T-IM-1ETH-BR-pp
Loop-IP6610-T-IM-1ETH-BR-pp-G
For DTE WAN portï¼s
Loop-IP6610-DTE-1ETH-BR-pp
Loop-IP6610-DTE-1ETH-BR-pp-G
Accessories
E1 Line Interface
Line Rate 2.048 Mbps ± 50 ppm Connector BNC (75 ohm), RJ48C (120 ohm) Data Rate n x 64Kbps (n=1 to 31) Output signal ITU G.703 Line Code AMI/ HDB3 Electric 75 ohm/ 120 ohm twisted pair Input Signal ITU G.703 Jitter ITU G.823
DS1 Line Interface
Line Rate 1.544 Mbps ± 32 ppm Line Code AMI/B8ZS Input Signal DSX-1 0dB to /30dB w/ALBO Jitter AT&T TR 62411 Data Rate n x 64Kbps (n=1-24) Framing D4/ESF Connector DA15S or RJ48C Output Signal DSX-1 w/0, -7.5, -15 dB LBO Pulse Template AT&T TR 62411 Surge Protection FCC Part 68 Sub Part D
DTE Interface- V.35 DTE Interface-V.36
Connector DB25 Connector DB25 Data Rate Up to 8.192 Mbps Data Rate Up to 7.143 Mbps
DTE Interface- EIA530 DTE Interface-RS232
Connector DB25 Connector DB25 Data Rate Up to 8.192 Mbps Data Rate Up to 128 Kbps
DTE Interface- X.21 DTE Interface-RS449
Connector DB15 Conversion DB25 to DB37 conversion cable Cable Data Rate Up to 8.192 Mbps Data Rate Up to 8.192 Mbps
LAN Interface WAN Interface
y Support SNMP management y Layer 2 protocol: HDLC, PPP, Frame Relay, Cisco y Physical interface 10/100 Mbps compatible HDLC y RJ45 connector y Single WAN port
y One or four Ethernet ports y Up to 10 Frame Relay PVCs y Embedded Ethernet switch for four Ethernet ports y Remote bridge support (padding/ un-padding Ethernet CRC checksum) y In-band management channel
Physical Interface Power Interface
y WAN: E1/FE1, DS1/FDS1 (Integrated CSU/DSU) y AC : Full range support 100 / 240V DTE (V.35/ V.36/ X.21/ RS232/ EIA530/ y DC: 24V or 48V support RS449) y Power consumption: Max. 6 watt
y LAN: 10/100 Base-T Ethernet port Speed auto-sensing Half/full duplex auto-negotiation Auto MDI-X
Routing Protocol NAT
y Static Route y NAT y RIP v1 & v2 y NAPT
DHCP Port Forwarding
y DHCP server support for LAN users (RFC2131, y Static/dynamic address/port forwarding table for NAT and RFC2132 NAPT y BOOTP compatible
SNTP
Access Control & Firewall
y SNTP client support y Packet filtering based on
y Sync with up to 4 time servers Inbound/outbound direction Source/destination IP address Protocol types (ICMP, TCP, UDP) Port number rang
y Up to 4 control lists
Remote Bridge Management
y PPP/BCP y User configurable aging time y Up to 16K MAC Table y Cisco ISL packet transparent y VLAN packet transparent y SNMP v1/v2 y MIB: MIBII,Transmission MIB y Telnet y HTTP Web-based managesment y Serial console with CLI
y VLAN ID mapping (802.1q) y Bridge with IP y 802.1w Rapid Spanning Tree Protocol
y TFTP firmware download y Configuration upload/ download y SNMP/ Telnet via data channel/ In-band Management channel
Administration & Diagnostics Console Port
y Ping Connector
y Trace route Electric y Loopback Protocol DB9S y Telnet RS232 y SSH
CLI
Diagnostics Test
Loopbacks For E1/ DS1: Line Loopback, Payload Loopback, Local Loopback, Router to Line Loopback For DTE: DTE to DTE Loopback Test Pattern For E1: 15-bit PRBS, 3-in-24, 1-in-8, 2-in-8, 1:1 For DS1: 20-bit QRSS, 3-in-24, 1-in-8, 2-in-8, 1:1 Idle Channel For E1: Use of idle channel to perform PRBS diagnostic test For DS1: Use of idle channel to perform QRSS diagnostic test
Performance Monitor
Performance Store Last 24 hours performance in 15-minute intervals and last 7 days in 24-hour summary line, user, and remote site Performance Reports Date & Time, Errored Second, Unavailable Second, Bursty Errored Second, Severe Errored Second, Controlled Slip Second, and Loss of Frame Count Alarm History Date & Time, Alarm Type, and Location Alarm Queue Maximum 40 alarm records which record the latest alarm type, location, and date & time
Physical
Dimensions 210 x 41.5 x 140 mm. (WxHxD) Temperature 0 -50°C Humidity 0-95% RH (NON-CONDENSING) Mounting Desk-top stackable, wall mount
Compliance
EMC FCC15 Class A EN300 386 Safety UL60950 ETL/ETLC, IEC60950 CB FCC FCC68
LAN
© 2006 Loop Telecommunication International, Inc. All Rights Reserved Version 8. 01 AUG 2006 Subject to change without notice.